7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Page 243 of 248 HP Insight Remote Support (7.0.8)
Glossary
A
Agentless Management Service (AMS)
iLO 4 Agentless Management uses out-of-
band communication for increased security
and stability. With Agentless Management,
health monitoring and alerting is built into the
system and begins working the moment a
power cord is connected to the server. This
feature runs on the iLO hardware,
independent of the operating system and
processor. The separately installed AMS
collects additional operating system data.
AMS
See Agentless Management Service.
C
CDID
See Custom Delivery ID.
Central Management Server (CMS)
The CMS is a system in the management
domain that executes the HP Systems
Insight Manager software. All central
operations within HP Systems Insight
Manager are initiated from this system.
Centralized Management Console (CMC)
The CMC is used to configure and manage
the P4000 Storage Systems.
CLIQ
Legacy term for the SAN/iQ command line
interface. See P4000 CLI.
Cluster
A cluster is a grouping of storage nodes that
create the storage pool from which you
create volumes.
collection schedules
The frequency in which collections are run.
The schedule is configurable in the Insight
RS Console.
collections
The term within HP SIM for grouping system
or event searches. While HP SIM uses the
term collection in reference to a group of
monitored devices, Insight Remote Support
uses the term configuration collection in
reference to data collected from a monitored
device. This data is communicated to HP for
proactive analysis.
configuration collection
HP Insight Remote Support uses the term
configuration collection in reference to data
collected from a monitored device. This data
is sent to HP for proactive analysis.
Custom Delivery ID
The Custom Delivery ID is a free text field
that can be individually populated for each
monitored device. Unless a specific value is
specified within the documentation relating
to configuring a particular device, the field
should be left blank. In some very specific
circumstances, this field may also be
populated by an HP Representative to allow
customized handling/routing of reported
incidents. In those instances, the field must
be populated with a unique value associated
with the customized handling that is
required. Determination of the unique value
must be done by the HP Representative
working with the HP Automation Team TS
that sets up the customizations. Failure to
follow this guidance could result in
incorrectly handled incident reports.