7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 34: Configuring Uninterruptable Power Supplies
Discover the Device in the Insight RS Console
To discover the device from the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the main menu, select Discovery and click the Sources tab.
3. Expand the IP Addresses section and add the IP address for your device:
a. Click New.
b. Select the Single Address, Address Range, or Address List option.
c. Type the IP address(es) of the devices to be discovered.
d. Click Add.
4. Click Start Discovery.
Send a Test Trap
To send a test trap, complete the following steps:
1. Log on to the UPS Network Module web interface.
2. In the left menu, click Notified Applications, then click Add Trap Receiver. Up to three
applications can be configured to receive SNMP traps from the UPS Network Module.
3. Click Utility Failure Test. The UPS Network Module sends a Utility failure trap, and then sends a
Utility restored trap 30 seconds later.
4. Verify that Insight Remote Support received the test trap.
HP Insight Remote Support (7.0.8)Page 228 of 248