7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 34: Configuring Uninterruptable Power Supplies
Task Complete?
Discover the UPS Network Module in the Insight RS Console.
Send a test event to verify connectivity between your UPS Network Module and Insight
RS.
Configure SNMP
SNMP can be setup in the SNMP Settings screen in the UPS Network Module web interface. The SNMP
Settings screen allows an administrator to configure SNMP settings for computers that use the HP Power
MIB to request information from the UPS Network Module.
For more details about configuring SNMP, see the HP UPS Network Module User Guide.
To configure SNMP, complete the following steps:
1. Log on to the UPS Network Module web interface.
2. In the left menu, click SNMP.
3. Select the SNMP version from the SNMP Version drop-down list.
4. Fill in the appropriate fields.
5. Click Save.
6. Set the Hosting Device as a trap receiver UPS Network Module web interface. The Trap Receivers
Settings screen allows an administrator to configure management applications to receive SNMP
traps from the UPS Network Module. SNMP management applications, such as Insight Remote
Support, can receive notifications from the UPS Network Module.
To configure the Hosting Device as an SNMP trap recipient, complete the following steps:
a. In the left menu, click Notified Applications, then click Add Trap Receiver. Up to three
applications can be configured to receive SNMP traps from the UPS Network Module.
HP Insight Remote Support (7.0.8)Page 226 of 248