7.0.8 Insight Remote Support Monitored Devices Configuration Guide
Chapter 34
Configuring Uninterruptable Power Supplies
Uninterruptable Power Systems (UPS) come with either a Management Module or a Network Module
installed, depending on the model. Use the appropriate configuration procedure below for your model:
l To configure a UPSthat uses a Management Module, see "Configuring UPS Management Modules"
below.
l To configure a UPSthat uses a Network Module, see "Configuring UPS Network Modules" on page
225.
Configuring UPS Management Modules
The Uninterruptable Power Systems (UPS) Management Module is an option in several HP Rack-
Mountable and Tower UPS units, and these units can be monitored by Insight Remote Support through the
module.
Important: Configuration collections are not supported.
Fulfill Configuration Requirements
Complete the following steps to configure your UPS Management Modules to be monitored by Insight RS.
Task Complete?
Make sure Insight RS supports your UPS Management Module by checking the HP
Insight Remote Support Release Notes.
Configure SNMP on the UPS Management Module and set the Hosting Device as a trap
receiver.
Add the SNMP protocol to the Insight RS Console.
Discover the UPS Management Module in the Insight RS Console.
Send a test event to verify connectivity between your UPS Management Module and
Insight RS.
Table 34.1 UPS Management Module Configuration Steps
Configure SNMP
SNMP can be setup in the SNMP Traps screen in the UPS Management Module web interface.
For more details about configuring SNMP, see the HP UPS Management Module User Guide.
To configure SNMP trap notifications, complete the following steps:
HP Insight Remote Support (7.0.8)Page 223 of 248