7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 33: Configuring ComWare-based Networking Switches
d. Click Add.
4. Click Start Discovery.
Verifying SNMP Communication
There is not a way to manually verify the SNMP configuration without generating an event, which can only
be accomplished by performing an action like pulling a fan tray or disconnecting a power supply.
Note: Do not pull a redundant FRU to test the configuration.
You can verify SNMP communication by reviewing the running configuration from the ComWare-based
switch command line. Look for the snmp-agent section in the output and verify that the community string
is correct and the trap destination is the Hosting Device.
To display the running configuration, run the following command:
> display current-configuration
#
snmp-agent
snmp-agent community read public
snmp-agent sys-info version v1
snmp-agent target-host trap address udp-domain <hosting_device_ip> params securitynam
e public v1
#
If any of the settings are incorrect, use the undo command to remove the setting, for example, undo
snmp-agent community read public. Then return to "Setup SNMP Traps" on the previous page and
reconfigure the setting that was incorrect.
HP Insight Remote Support (7.0.8)Page 222 of 248