7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 32
Configuring Provision-based Networking
Switches
Provision-based networking switches (formerly E-series/ProCurve) require SNMP for discovery and event
monitoring. Provision-based switches ship with SNMP installed and enabled.
You can use either Telnet or SSH for configuration collections. Telnet is enabled on Provision-based
switches by default. If you want to use SSH for configuration collections, you must enable it (see section
"Enabling SSH").
Fulfill Configuration Requirements
Complete the following steps to configure your Provision-based networking switches to be monitored by
Insight RS.
Task Complete?
Make sure Insight RS supports your Provision-based switch by checking the HP Insight
Remote Support Release Notes.
Create Operator/Manager passwords on the switch.
Configure SSH on the switch.
Configure SNMP on the switch.
Add the Telnet or SSH and SNMP protocols to the Insight RS Console.
Discover the Provision-based switch in the Insight RS Console.
Table 32.1 Provision-based Networking Switch Configuration Steps
Create Operator/Manager Passwords
It is required that you set a manager password.
To set a manager password, complete the following steps:
1. Type the password all command. You are prompted to type manager and operator passwords:
# password all
2. Type the password manager command to set the manager password:
# password manager
Configure SSH
Generate the Public/Private key for SSH
HP Insight Remote Support (7.0.8)Page 213 of 248