7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 29: Configuring StoreFabric B-Series Switches
Entry 3: No access host configured yet
Entry 4: No access host configured yet
Entry 5: No access host configured yet
8. Set MIB Capability:
> snmpconfig --set mibcapability
The SNMP Mib/Trap Capability has been set to support FE-MIB SW-MIB FA-MIB HA-MIB
SW-TRAP FA-TRAP HA-TRAP
FA-MIB (yes, y, no, n): [yes]
FICON-MIB (yes, y, no, n): [no]
HA-MIB (yes, y, no, n): [yes] yes
FCIP-MIB (yes, y, no, n): [no]
ISCSI-MIB (yes, y, no, n): [no]
SW-TRAP (yes, y, no, n): [yes]
swFCPortScn (yes, y, no, n): [no] yes
swEventTrap (yes, y, no, n): [no] yes
swFabricWatchTrap (yes, y, no, n): [no] yes
swTrackChangesTrap (yes, y, no, n): [no] yes
FA-TRAP (yes, y, no, n): [yes]
connUnitStatusChange (yes, y, no, n): [no] yes
connUnitEventTrap (yes, y, no, n): [no] yes
connUnitSensorStatusChange (yes, y, no, n): [no] yes
connUnitPortStatusChange (yes, y, no, n): [no] yes
SW-EXTTRAP (yes, y, no, n): [no] yes
9. Display the IP address of the switch, so it can be added to the Insight RS Console:
> ipaddrshow
SWITCH Ethernet IP Address: 1.2.3.4
Ethernet Subnetmask: 1.2.3.4
Fibre Channel IP Address: none
Fibre Channel Subnetmask: none
Gateway IP Address: 1.2.3.4
DHCP: Off
10.
Modify the switch systemgroup variables if required:
> snmpconfig --set systemGroup
HP Insight Remote Support (7.0.8)Page 205 of 248