7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 29
Configuring StoreFabric B-Series Switches
Fulfill Configuration Requirements
Complete the following steps to configure your StoreFabric B-Series Switches to be monitored by Insight
RS.
Note: Test trap support for B-series SAN switches requires the installation of Fabric Operating
System v6.3.0b firmware or higher. See the HP Fabric OS 6.3.0b Customer Advisory for details,
at:
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectI
D=c01924282.
Task Complete?
Make sure Insight RS supports your B-Series switch by checking the HP Insight
Remote Support Release Notes.
Configure SNMPv1 on the B-Series switch.
Add the SNMP protocol to the Insight RS Console.
Discover the B-Series switch in the Insight RS Console.
Verify the status of the B-Series switch in the Insight RS Console.
Send a test event to verify connectivity between your B-Series switch and Insight RS.
Table 29.1 StoreFabric B-Series Switch Configuration Steps
Configure SNMP
Use the following procedure to configure SNMP on a B-Series switch so that it can be monitored with
Insight Remote Support.
1. Display switch firmware version:
> version
Fabric OS: v6.1.0c
2. Display the current or default SNMPv1 settings:
> snmpconfig --show snmpv1
SNMPv1 community and trap recipient configuration:
Community 1: public (rw) No trap recipient configured yet
Community 2: public (rw) No trap recipient configured yet
Community 3: public (rw) No trap recipient configured yet
HP Insight Remote Support (7.0.8)Page 202 of 248