7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 27: Configuring StoreOnce Backup (D2D) Systems
5. Use the Hosting Device IP address to add a destination.
Configure SNMP for StoreOnce B6200 and
2600/4200/4400 Backup Systems
To configure the StoreOnce Backup B6200 and 2600/4200/4400 Backup Systems to send traps to Insight
Remote Support, complete the following steps:
1. Log on to the StoreOnce Backup System using the SSH protocol (Using "putty.exe" or a similar tool).
2.
Check the current SNMP configuration by issuing the CLI command: snmp show config.
3.
If the SNMP "State" displays as "off" run the CLI command: snmp enable.
4.
To add your Hosting Device as a Trap Destination use: snmp add trapsink <IP address of
Hosting Device> events alert.
5. Check that the current SNMP configuration shows the trap destination that you just configured by
using: snmp show config.
6.
Type exit to log off.
Create an SNMP Protocol Credential in Insight RS
If your device's SNMP community string is set to public and your community access mode is read
only, Insight RS automatically associates an SNMPv1 protocol with your device. If you use a different
HP Insight Remote Support (7.0.8)Page 191 of 248