7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 27
Configuring StoreOnce Backup (D2D) Systems
Fulfill Configuration Requirements
Complete the following steps to configure your StoreOnce Backup (D2D) Systems to be monitored by
Insight RS.
Task Complete?
Make sure Insight RS supports your StoreOnce Backup (D2D) System by checking the
HP Insight Remote Support Release Notes.
Verify Firmware version on the StoreOnce Backup (D2D) System.
Configure SNMP on the StoreOnce Backup (D2D) System.
Add the SNMP protocol to the Insight RS Console.
Discover the StoreOnce Backup (D2D) System in the Insight RS Console.
Table 27.1 StoreOnce Backup (D2D) System Configuration Steps
Verify the Firmware Version
Insight RS only supports StoreOnce Backup systems that use firmware version 2.1.03 or above. Check
the firmware version in the StoreOnce Backup user interface as shown below. If your firmware version is
older than version 2.1.03, update your firmware to a supported version.
Configure SNMP for StoreOnce Backup (D2D) Systems
To configure SNMP for StoreOnce Backup (D2D) Systems, complete the following steps:
1.
Log on to the StoreOnce Backup System as "administrator" using https://<StoreOnce_Backup_
IP>.
2. Click the Configuration tab.
3. On the Device Configuration pane, click the SNMP tab.
4. Click Edit, then enable the SNMP agent by selecting the SNMP Enabled check box.
HP Insight Remote Support (7.0.8)Page 190 of 248