7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 26
Configuring Virtual Library Systems
Fulfill Configuration Requirements
Complete the following steps to configure your Virtual Library Systems to be monitored by Insight RS.
Task Complete?
Make sure Insight RS supports your Virtual Library System by checking the HP Insight
Remote Support Release Notes.
Configure SNMP on the Virtual Library System.
Discover the Virtual Library System in the Insight RS Console.
Send a test event to verify connectivity between your Virtual Library System and Insight
RS.
Table 26.1 Virtual Library System Configuration Steps
Configure SNMP on the Virtual Library System
To support your Virtual Library System (VLS) Tape Libraries, you need to configure SNMP in Command
View for Virtual Library Systems (VLS).
To configure SNMP on your VLS Tape Libraries, complete the following steps:
1. Log on to the Command View VLS web interface of each VLS node.
2. Click the Notifications tab.
3. Click the Edit SNMP settings task. Note that this task may be called SNMP Setup, depending on
your version of Command View VLS.
4. In the Hostname field, type the Hosting Device IP address or FQDN.
5. In the Community String field, if you select a non-standard trap community name (for example,
something other than public), verify the Insight RS Console recognizes this name.
HP Insight Remote Support (7.0.8)Page 188 of 248