7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 23: Configuring P2000 G3 Modular Smart Arrays
Discover the Device in the Insight RS Console
To discover the device from the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the Main Menu, select Discovery and click the Sources tab.
3. Expand the IP Addresses section and add the IP address for your device:
a. Click New.
b. Select the Single Address, Address Range, or Address List option.
c. Type the IP address(es) of the P2000 G3 devices to be discovered.
Important: In a dual-controller system, you must discover both controller A and
controller B if both exist. If you do not discover both controllers, events that originate
from the controller that was not discovered could be lost.
d. Click Add.
4. Click Start Discovery.
Verify Service Event Monitoring
To send a test event from the P2000, complete the following steps:
1. In a web browser, log on to the HP MSA Storage Management Utility (SMU).
2. Select Tools → Send Test Notification.
3. In the Send Test Notifications window, click Send.
4. Click OK to acknowledge that the message was sent.
5. Sign out of SMU.
HP Insight Remote Support (7.0.8)Page 179 of 248