7.0.8 Insight Remote Support Monitored Devices Configuration Guide
Monitored Devices Configuration Guide
Chapter 23: Configuring P2000 G3 Modular Smart Arrays
6. Click Apply to commit your changes.
7. Exit the utility and discover your P2000 G3 in the Insight RS Console.
About WBEM on the P2000 G3
The SMI-S provider for the P2000 G3 MSA is integrated in the firmware and delivered with the P2000 G3
series disk arrays. It provides a WBEM-based management framework. Insight RS can interact with this
embedded provider directly and does not need an intermediate proxy provider.
No configuration of WBEMon the P2000 G3 is necessary.
Create an SNMP Protocol Credential in Insight RS
If your device's SNMP community string is set to public and your community access mode is read
only, Insight RS automatically associates an SNMPv1 protocol with your device. If you use a different
community string or use a nonstandard port, you must create an SNMPv1 protocol credential in the Insight
RS Console.
To configure SNMPv1 in the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the main menu, select Discovery and click the Credentials tab.
3. From the Select and Configure Protocol drop-down list, select Simple Network Management
Protocol Version 1.
4. Click New. The New Credential dialog box appears.
5. Enter the Community String you have configured on your device.
6. Click Add.
Insight RS creates the protocol credential and it appears in the credentials table.
Create a WBEM Protocol Credential in Insight RS
To configure WBEM in the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the main menu, select Discovery and click the Credentials tab.
3. From the Select and Configure Protocol drop-down list, select Web-Based Enterprise
Management (WBEM).
4. Click New. The New Credential dialog box appears.
5. Enter the Username and Password used to access the Storage Management Utility interface on the
P2000.
6. Click Add.
Insight RS creates the protocol credential and it appears in the credentials table.
HP Insight Remote Support (7.0.8)Page 178 of 248