7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 20: Configuring MSA15xx Modular Smart Arrays
5. Modify any necessary configuration fields and make sure that the IP address of the Hosting Device is
listed as a Trap Address.
6. Click OK to commit your changes.
7. Exit the utility and discover your 1510i in the Insight RS Console.
Create an SNMP Protocol Credential in Insight RS
If your device's SNMP community string is set to public and your community access mode is read
only, Insight RS automatically associates an SNMPv1 protocol with your device. If you use a different
community string or use a nonstandard port, you must create an SNMPv1 protocol credential in the Insight
RS Console.
To configure SNMPv1 in the Insight RS Console, complete the following steps:
HP Insight Remote Support (7.0.8)Page 165 of 248