7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 19: Configuring StoreVirtual P4000 Storage Systems
Insight RS supports CMC 9.0 and higher (CMC 11.0 is recommended)
CMC 11.0 can be used to manage LeftHand OS 9.x, 10.x, and 11.0 storage nodes.
CMC, Windows version has the following requirements:
Memory Size Free Disk Space
100 MB RAM during run-time 150 MB disk space for complete install
Table 19.2 Memory and storage requirements for CMC
Note: CMC can be installed on the Hosting Device or it can be install on a separate system. If
CMC is already installed on another system, it does not need to be installed on the Hosting
Device.
Install the centralized management console (CMC) on the computer that you will use to administer the
SAN. You need administrator privileges while installing the CMC.
1. Insert the P4000 Management SW DVD in the DVD drive. The installer should launch automatically.
Or, navigate to the executable (:\GUI\Windows\Disk1\InstData\VM\CMC_Installer.exe)
Or download CMC at: http://www.hp.com/go/P4000downloads.
Click the Complete install option, which is recommended for users that use SNMP.
Note: If you already have Service Console installed, you don't need to disable it. Insight
Remote Support can co-exist with Service Console without conflict.
2. Use the Find Nodes wizard to discover the storage systems on the network, using either IP
addresses or host names, or by using the subnet and gateway mask of the storage network.
HP Insight Remote Support (7.0.8)Page 149 of 248