7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 19
Configuring StoreVirtual P4000 Storage Systems
HP Insight Remote Support software delivers secure remote support for your HP servers, storage,
network, and SAN environments, which includes the P4000 SAN.
Note: HP StoreVirtual Storage is the new name for HP LeftHand Storage and HP P4000 SAN
solutions. LeftHand Operating System (LeftHand OS) is the new name for SAN/iQ.
Important: Each P4000 device counts as three counts as three monitored devices under Insight
RS, therefore Insight RS can only support a maximum of approximately 150 P4000 devices.
Important: For every 100 P4000 devices being monitored by Insight RS, add 1 GB of free disk
space to the Hosting Device requirements.
P4000 documentation is available at: http://www.hp.com/support/manuals. In the Storage section, click
Disk Storage Systems and then select HP LeftHand P4000 SAN Solutions.
Fulfill Configuration Requirements
Complete the following steps to configure your P4000 Storage Systems to be monitored by Insight RS.
Task Complete?
Make sure Insight RS supports your P4000 Storage System by checking the HP Insight
Remote Support Release Notes.
Install or upgrade CMC on the Hosting Device.
Install or upgrade LeftHand OS on the P4000.
Configure SNMP on the P4000.
Add the P4000 SAN Solution (SAN/iQ) protocol to the Insight RS Console.
Discover the P4000 Storage System in the Insight RS Console.
Send a test event to verify connectivity between your P4000 Storage System and
Insight RS.
Table 19.1 P4000 Storage System Configuration Steps
Install and Configure CMC on the Hosting Device
You need to do the complete install of Centralized Management Console (CMC) to install the SNMP
MIBs. If you do not modify the SNMP defaults that CMC uses, then SNMP should work with Insight
Remote Support without modification.
HP Insight Remote Support (7.0.8)Page 148 of 248