7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 15: Configuring IBM Servers
11. From the SNMPv1 agent drop-down list, select Enabled.
12. Configure an SNMPv1 Community:
a. In the Community Name field, type a SNMP community name.
b. From the Access Type drop-down list, select Get.
c. In the Host Name or IP Address field, type the Hosting Device host name or IP address.
13. Click Save.
14. Restart the BladeCenter Management Module:
a. In the MM Control section of the left menu, select Restart MM.
b. Click Restart.
Install IBM Device Drivers and Service Processor
Firmware
To use an attached device, its device drivers must be installed. Make sure that the appropriate IBM
server’s service processors are installed.
Note:
HP Insight Remote Support (7.0.8)Page 119 of 248