7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 14
Configuring Tru64 UNIX Servers
Important: Configuration collections are not supported on HP AlphaServer products.
Important: HP only provides limited remote support for customers using HP Alpha servers. As
with standard support, HP Insight Remote Support version 7.x will attempt to discover these
products as remotely monitored HP products and send information about failure events to HP.
However, if there are issues with the operation of the remote monitoring features of HP Insight
Remote Support version 7.x for these specific products, including the remote discovery or the
reporting of failure events to HP, then HP will resolve such issues in a commercially reasonable
manner but without guarantee of an immediate response or a resolution. If a failure event is
successfully received at HP, it is managed according to the support level agreement.
Fulfill Configuration Requirements
Complete the following steps to configure your Tru64 UNIX servers to be monitored by Insight RS.
Task Complete?
Make sure Insight RS supports your Integrity Tru64 server by checking the HP Insight
Remote Support Release Notes.
Install and configure ELMC for Tru64 on the Tru64 UNIX server.
Add ELMC to the Insight RS Console.
Discover the Tru64 server in the Insight RS Console.
Table 14.1 Tru64 UNIX Server Configuration Steps
Fulfill ELMC System Requirements
Tru64 UNIX monitored devices must meet the following requirements before ELMC is installed. In
clusters, minimum requirements apply to each node in the cluster.
Hardware and Software Requirements
l Processor architecture: HP AlphaServer
l Operating system: Tru64 UNIX version 4.0F, 4.0G, 5.1A or higher
Note: HP Sustaining Engineering maintains a schedule of support for the Tru64 UNIX
operating system. HP does not commit to supporting Insight Remote Support when installed
on an operating system version that has exceeded its end-of-support date.
HP Insight Remote Support (7.0.8)Page 107 of 248