7.0.8 Insight Remote Support Installation and Configuration Guide

Installation and Configuration Guide
Chapter 5: Restoring from Backup
net stop hprsmain
3. Restore your backup data set:
rsadmin restore –source <backup_data_set>
where backup_data_set is the location of your backup data set.
The default backup location is C:\ProgramData\HP\RS\DATA\backup. If you change the source
location, then make sure you include the time stamp folder name, for example,
E:\backup\1350683403365.
4. Restart the Insight RS services:
net start hprsmain
net start hprsreceivers
After restarting the Insight RS services, the database re-initializes with the backup data. Note that the re-
initialization takes a few minutes, and the Insight RS Console will not be accessible during this time.
HP Insight Remote Support (7.0.8)Page 66 of 80