7.0.8 Insight Remote Support Installation and Configuration Guide

Installation and Configuration Guide
Chapter 3: Completing the Setup Wizards
access credentials in the Select Type drop-down list. You can also identify a sub device type in the
Select Sub-Type drop-down list to further filter the list of protocols.
The Select and Configure Protocol drop-down list is filtered according to your selection(s).
2. From the Select and Configure Protocol drop-down list, select the appropriate protocol.
3. Click New. The New Credential dialog box appears with fields for the protocol you selected.
4. Complete the fields in the New Credential dialog box.
Note: The available fields depend on the protocol that you select.
The following table describes the different fields you will see when working with different protocols:
Credential Field Description
Priority Select a priority from the drop-down list. Credentials with a higher set
priority will be attempted before credentials with a lower set priority.
For example, a set of credentials with a priority of 1 will be executed
first during the discovery process.
Type Select a credential type from the drop-down list. For example,
Username Password Credential, Certificate Credential, Anonymous
Credential. Selecting a new credential type changes the available
fields in the window.
Port Contains the default port number.
Use default Clear this check box if you do not want to use the default port number.
Type the appropriate port number in the Port field.
HP Insight Remote Support (7.0.8)Page 37 of 80