Insight Remote Support Advanced for NonStop

NOTE: This needs to be done once for each NonStop system when using HP Insight Remote
Support Advanced and/or most Nonstop Essentials products – it is done automatically for
NonStop Cluster Essentials. So, if you have already installed NonStop Cluster Essentials or
performed these steps while configuring the system for one of those other products, you do
not need to repeat them as part of Insight Remote Support Advanced.
Registering for WBEM Alerts
If not already done, perform one of the following to register a NonStop system to receive
WBEM alerts:
• After you perform Step 7, select Subscribe for WBEM events from the Options/Events
menu in HP SIM.
• In the First Time Wizard, under Configure Managed Systems, select Configure newly
managed systems when they are first discovered. From the Configure WBEM/WMI check
list, select Create subscription for WBEM events. This option is useful if you are managing
only NonStop systems from the CMS, as HP SIM will try all Global Credential, or those
specified in the discovery task for individual systems during discovery and will start using
WBEM to receive alerts from OSM automatically, provided the credentials match.
NOTE: If you have entered global credentials in Step 7, this step might already be
done.
Registering for WBEM Lifecycle Events
If not already done, after system discovery, perform the following command to register a
NonStop system to receive WBEM lifecycle events:
mxwbemsub –a –n <system_name_address> -t health
Where <system_name_address> is either the DNS name or the IP address of the NonStop
system.
To verify if the system is currently registered for the WBEM lifecycle events, enter:
mxwbemsub -l -n <system_name_address>
9. After each system has been discovered, enable it for Insight Remote Support Advanced by
entering the following NonStop entitlement values through the Edit System Properties page in
12 Installation and Configuration of HP SIM and Insight Remote Support Advanced