A.05.80 HP Insight Remote Support Advanced Managed Systems Configuration Guide (June 2013)
Table Of Contents
- Managed Systems Configuration Guide
- Contents
- About This Document
- Insight Remote Support Advanced Managed Systems Overview
- ProLiant Windows Server Configuration
- ProLiant Linux Server Configuration
- ProLiant VMware ESX Server Configuration
- ProLiant VMware ESXi Server Configuration
- Proliant Citrix Server Configuration
- ProLiant c-Class BladeSystem Enclosure Configuration
- Integrity Windows 2003 Server Configuration
- Integrity Windows 2008 Server Configuration
- Integrity Linux Server Configuration
- Integrity Superdome 2 Server Configuration
- HP-UX Server Configuration
- Meeting HP-UX Operating System, Software, and Patch Requirements
- More About WBEM and SFM with Insight Remote Support
- Verifying System Fault Management is Operational
- Creating WBEM Users
- Configuring WEBES to Support WBEM Indications
- Firewall and Port Requirements for HP-UX Managed Systems
- Configuring HP-UX Managed Systems for Proactive Collection Services
- OpenVMS Server Configuration
- Tru64 UNIX Server Configuration
- NonStop Server Configuration
- Enterprise Virtual Array Configuration
- Understanding the Different Server Types and Software Applications
- Command View EVA 8.0.1 and Higher Hosted on the CMS
- Important Port Settings Information
- Important Information Regarding New HP SIM Installations
- Correcting an Existing HP SIM Installation
- Change the WMI Mapper Proxy port in the HP SIM User Interface on the CMS
- Restore Defaults to the wbemportlist.xml file
- Installing and Configuring Command View EVA After HP SIM
- Resetting the Port Numbers when Command View EVA was Installed before HP SIM
- Command View EVA Hosted on a Separate SMS
- Requirements and Documentation to Configure Command View EVA on the SMS
- Overview of Command View EVA 7.0.1 through 8.0.1 with SMI-S Requirements
- SMS System and Access Requirements
- WEBES – EVA Communication
- HP SIM – EVA Communication
- Software Required on the SMS
- Fulfilling ELMC Common Requirements for a Windows SMS
- Installing MC3 on the SMS
- Configuring EVA-Specific Information on the CMS
- Requirements to Support EVA4400 and P6000 with Command View EVA on the ABM
- Enabling User-Initiated Service Mode in Command View EVA 9.3
- Performing a Remote Service Test in Command View EVA 9.3
- Troubleshooting EVA Managed Systems
- P4000 Storage Systems Migration Procedure
- Network Storage System Configuration
- Modular Smart Array Configuration
- Tape Library Configuration
- System Requirements
- Managed Systems Configuration
- Nearline (Tape Library) Configuration
- Secure Key Manager Configuration
- StoreOnce D2D (Disk-to-Disk) Backup System Configuration
- Enterprise Systems Library G3 Configuration
- TapeAssure Service Configuration
- Prerequisites
- Command View for Tape Libraries and TapeAssure Service Installation
- Configure the Command View TL 2.8 CIMOM and TapeAssure Provider
- Configure the Command View TL 3.0 CIMOM and TapeAssure Provider
- HP SIM Device Discovery
- WEBES Configuration
- Create a New SMI-S Protocol in WEBES
- Subscribe to the Command View TL and TapeAssure CIMOM
- SAN Switch Configuration
- E-Series Switch Configuration
- A-Series Switch Configuration
- UPS Network Module Configuration
- Modular Cooling System Configuration
- Glossary
- Index
Managed Systems Configuration Guide
Chapter 12: HP-UX Server Configuration
Software and Patch Requirements for HP-UX 11i v2
Important: While not required for HP-UX 11i v2 (11.23), it is strongly recommended to use
QPKBASE B.11.23.0712.070 Base Quality Pack Bundle for HP-UX 11i v2
(December 2007).
Installing QPKBASE B.11.23.0712.070 fulfills all system patch requirements and provides the
customer with a stable supported environment. The following table identifies the minimum required
patches (required if QPKBASE B.11.23.0712.070 is not installed).
Note: Notes About the Following Table
l WBEM Services, Online Diagnostics, SysMgmtWeb, and HP SIM are available on the Operating
Environment (OE) media and can be selected for install during the SFM installation. Insight
Remote Support Advanced does not support HP SIM on HP-UX.
l The listed software versions are the minimum supported requirements. Newer versions are
supported unless otherwise noted.
l System Management Homepage (SMH), bundled in SysMgmtWeb, is optional. However, if it is
not installed you cannot access the Event Viewer (EvWEB) user interface.
l The table lists the items in the sequence in which they should be installed in case any of them are
missing and require upgrade or installation.
Required Software Version Required
HP-UX Operating Environment l September, 2004 11i v2 OE (minimum OE
release)
l May, 2005 11i v2 OE (required for vPars
enablement).
How to Download or Access Software:
http://h20338.www2.hp.com/hpux11i/cache/324923-0-0-0-121.html
Operating System Patch Requirements
Note: These six additional patches for HP-UX
11i v2 are NOT part of the Bundle11i and must
be installed in addition to it.
BUNDLE 11i patch bundle B.11.23.0409.3
(September, 2004):
l PHKL_36288 - 11.23 Cumulative diag2 driver
and vPars enablement (use in place of PHKL_
32653), requires a reboot
l PHKL_34795 - 11.23 Cumulative IPMI driver
patch, requires a reboot
l PHSS_37552 1.0 Aries cumulative patch
l PHSS_37947 1.0 linker + fdp cumulative patch
Table 12.2 Required Software Components for HP-UX 11i v2
HP Insight Remote Support Advanced (A.05.80)Page 73 of 204