A.05.80 HP Insight Remote Support Advanced Managed Systems Configuration Guide (June 2013)

Managed Systems Configuration Guide
Chapter 22: E-Series Switch Configuration
n x.14.60 and lower:
# snmp-server host <IP address> public not-info
n x.14.61 and higher:
# snmp-server host <IP address> community public trap-level not-info
5. Verify that the settings you just entered were saved:
# sho run
Verifying Telnet/SSH Communication
Use the following procedure to verify that Telnet or SSH communication is working properly:
1. From the CMS, connect to the E-series switch using the protocol you want to verify. Wait until the
connection is established.
2. Enter the username and password when prompted. If any of the following messages do occur then,
it is treated to be a login failure:
n
Login incorrect
n
User authorization failure
n
Invalid login name
n
Too many users logged on already
3. When the banner or login data is received, send a carriage return (\n) to make sure that the host is
ready.
4. Enter the command echo logged in to verify that you are really logged in and the prompt is ready
to accept the commands.
If the output logged in is echoed back, then the login was successful and connectivity has been
verified.
5. Enter the exit command to disconnect.
HP Insight Remote Support Advanced (A.05.80)Page 188 of 204