A.05.80 HP Insight Remote Support Advanced Managed Systems Configuration Guide (June 2013)

Managed Systems Configuration Guide
Chapter 20: Tape Library Configuration
Configure SNMPfor B6200 Backup System
To configure the StoreOnce B6200 Backup System to send traps to Insight Remote Support Advanced,
use the following procedure:
1. Log on to the StoreOnce B6200 using the SSH protocol (Using "putty.exe" or a similar tool)
2. Check the current SNMP configuration by issuing the CLI command: snmp show config.
3. If the SNMP "State" is displayed as "off" run the CLI command: snmp enable
4. To add your WEBES host as a Trap Destination use: snmp add trapsink <WEBES_host_IP_
address> events alert
5. Check that the current SNMP configuration shows the trap destination that you just configured by
using: snmp show config
6. Type exit to log off.
Enterprise Systems Library G3 Configuration
To support your Enterprise Systems Library (ESL) G3 Tape Libraries, you need to configure SNMP in the
ESL G3 user interface.
Use the following procedure to configure SNMP on your ESL G3 Tape Libraries:
1. Log on to the ESL G3 user interface as admin.
2. In the console, go to Setup → Network Configuration → Network Security Settings.
3. In the Security Configuration dialog box, select the SNMP/SMI-S tab.
Library health events are monitored with SNMP only. SMI-S need not be enabled unless it is required
for other Network Management software. Click Apply.
HP Insight Remote Support Advanced (A.05.80)Page 174 of 204