A.05.70 HP Insight Remote Support Advanced Release Notes (June 2012, 5900- 2129)

SysFaultMgmt requirements for HP-UX 11i v2

It is recommended to install:

 SysFaultMgmt B.07.01.01.yy System Fault Management (May, 2009) or later

If installing this version of SysFaultMgmt cannot be achieved, then SysFaultMgmt B.05.00.05 HPUX

System Fault Management (December 2007) is supported but not recommended as it has some known

issues that affect its operation:

 QXCR1000912086: cimprovagt uses 100% of CPU.

Problem Description: Initial 3 minutes SFM process uses more CPU and the cimprovagt program uses

100% of CPU on a vPar system on startup for a long time.

Fix: Update to SysFaultMgmt B.07.01.01.yy

 QXCR1000922279: SFMDB does not start when the time zone is GMT0.

Problem Description: On IA systems when Time Zone is set to GMT0, postmaster will stop and log

messages in sfmdb.log. This is because GMT0 is not a valid time zone recognized by PostgresSQL.

As a result, SFM database does not come up.

Fix: Update to SysFaultMgmt B.07.01.01.y

 QXCR1000923583: Error while switching from EMS to SFM mode.

Problem Description: While trying to switch from EMS to SFM mode, an error occurred. HA-OE: Err

on 1st boot:"error occurred when disabling EMS HW monitors

Fix: Update to SysFaultMgmt B.07.01.01.yy

IMPORTANT: While not required for HP-UX 11i v2, it is strongly recommended to use QPKBASE

B.11.23.0712.070 Base Quality Pack Bundle for HP-UX 11i v2 (December 2007), but it is not a

compulsory requirement for remote monitoring.

NOTE: See the System Fault Management Release Notes for more details and additional SFM

prerequisites at http://www.docs.hp.com/en/diag/sfm/sfm_0905_1123.htm.

Optional recommended software components for HP-UX 11i v2

 SysMgmtWeb A.2.2.7 HP-UX Web Based System Management User Interfaces, December 2007 or

later

Required software components for HP-UX 11i v3

 EVM-EventMgr B.11.31 or later

 Baseboard Management Controller (BMC) firmware version 05.21 or later

 SysMgmtBase B.00.02.03 or later

 OpenSSL Version A.00.09.07e.013 or later

 Online Diagnostics B.11.31.01.yy or later (SysFaultMgmt version dependency see notes below)

 WBEM Services Version A.02.05 or later

IMPORTANT: You are advised to check the WBEM Services Release Notes including the WBEM

Provider Compatibility Table for that product version, if you need to install or update this service.

SysFaultMgmt requirements for HP-UX 11i v3

It is recommended to install:

 SysFaultMgmt C.05.00.06.yy HPUX System Fault Management or later

which requires at a minimum:

 OnlineDiag B.11.31.05.yy Support Tools Bundle or later

It is also recommended to install the update to fix the following known issue