A.05.70 HP Insight Remote Support Advanced Managed Systems Configuration Guide (October 2011, 5900-1726)

Managed Systems Configuration Guide
Chapter 12: HP-UX Server Configuration
5. Select 'Q’ to exit the EMS Monitoring Request Manager Main Menu.
6. Disable EMS hardware monitors for HP-UX 11i v2 and 11i v3. HP-UX 11i v1 has only one mode,
which means that SFM uses EMS to report the events. You cannot disable EMS in 11i v1.
i. Check if SFM is used for hardware monitoring:
# /opt/sfm/bin/sfmconfig -w –q (not supported with 11i v1)
ii. If EMS is enabled for monitoring, switch to SFM using the command:
# /opt/sfm/bin/sfmconfig –w –s (not supported with 11i v1)
7. Run the following command to determine the version of the optional, but recommended, SMH
component is at least version A.2.2.6.2:
# swlist SysMgmtWeb SysMgmtHomepage
The output should look similar to the following:
8. Change the startup mode for SMH so that the autostart URL mode is set to OFF and start on boot
mode is set to ON:
HP Insight Remote Support Advanced (A.05.70)Page 79 of 199