A.05.70 HP Insight Remote Support Advanced Managed Systems Configuration Guide (October 2011, 5900-1726)

Managed Systems Configuration Guide
Chapter 12: HP-UX Server Configuration
Verifying System Fault Management is
Operational
To verify the System Fault Management (SFM) component is operational on a HP-UX managed system,
complete the following steps:
1. Run the following command to verify the HP WBEM Services for HP-UX component is installed:
# swlist | grep –i WBEM
The output should look similar to the following:
2. To list registered CIM providers and their current status to make sure that they are all enabled, run the
following command:
# cimprovider –l –s
3. Run the following command to check OnlineDiag is installed and make sure it is version B.11.11.16xx
or later.
# swlist | grep –i OnlineDiag
The output should look similar to the following:
4. Run the following command to check that OnlineDiag is reporting that Event Monitoring is Currently
Enabled and that EMS version is A.04.20 or later and the STM is A.49.10 or later:
# /etc/opt/resmon/lbin/monconfig
The output should look similar to the following:
HP Insight Remote Support Advanced (A.05.70)Page 78 of 199