A.05.70 HP Insight Remote Support Advanced Managed Systems Configuration Guide (October 2011, 5900-1726)

Managed Systems Configuration Guide
Chapter 11: Integrity Superdome 2 Server Configuration
a. On the CMS, open a DOS command prompt and type the following command:
mxwbemsub –a yyy.yyy.yyy.yyy –n xxx.xxx.xxx.xxx
where yyy.yyy.yyy.yyy is either the CMS’s IP address or FQDN, and xxx.xxx.xxx.xxx is
either the FQDN or IP address of the Superdome 2 OA.
Repeat this command substituting for xxx.xxx.xxx.xxx the IP address or FQDN for each OS
partition to be monitored.
b. List all of the active subscriptions on the Superdome 2 OA and OS partitions. On the CMS open a
DOS command prompt and type the following command:
mxwbemsub -l yyy.yyy.yyy.yyy -n xxx.xxx.xxx.xxx –s
where yyy.yyy.yyy.yyy is either the CMS’s IP address or FQDN, and xxx.xxx.xxx.xxx is
either the IP address or FQDN of the Superdome 2 OA or HP-UX partition.
The following ports will be referenced in the subscription list returned by this command:
o
7906 – WEBES
o
50004 – HP SIM
Generating Test Events
Superdome 2 Firmware version 2.2.27 or later supports the capability for an administrator to connect to the
OA and generate a WS-Man test indication. Use the following procedure to generate a WS-Man test
indication:
1. Telnet or SSH to the OA CLI interface and log on as administrator.
2. Enter the test wsman command.
3. Verify that the resultant WS-Man test indication was detected and reported in HP SIM both as a WS-
Man indication and as a Service generated by WEBES.
HP Insight Remote Support Advanced (A.05.70)Page 67 of 199