A.05.70 HP Insight Remote Support Advanced Managed Systems Configuration Guide (October 2011, 5900-1726)

Managed Systems Configuration Guide
Chapter 25: Modular Cooling System Configuration
1. Log on to the Modular Cooling System web interface.
2. Navigate to Setup → Management → System Information. The information entered on this screen
included with SNMP traps sent by the management module.
3. Enter the name of the management module in the System Name field.
4. Enter the name of the contact person in the System Contact field.
5. Enter the name of the location in the System Location field.
6. Enter the Read community string.
7. Enter the Write community string.
8. Enter the Trap community string.
9. Click Save Settings to save the information.
Configure SNMP Trap Receivers
In the Modular Cooling System web interface, set the Hosting Device as a trap receiver. The Trap
Receivers screen enables the Admin to enter information for servers that should receive SNMP traps from
the management module.
To configure the Hosting Device as an SNMP trap recipient, complete the following steps:
1. Log on to the Modular Cooling System web interface.
2. Navigate to Setup → Management → Trap Receivers.
HP Insight Remote Support Advanced (A.05.70)Page 192 of 199