A.05.70 HP Insight Remote Support Advanced Managed Systems Configuration Guide (October 2011, 5900-1726)
Managed Systems Configuration Guide
Chapter 21: SAN Switch Configuration
SNMP access list configuration:
Access host subnet area : [11.0.0.2] 1.2.3.4 ! set to the IP add of SIM
Read/Write? (true, t, false, f): [true]
Access host subnet area : [1.2.3.4] Read/Write? (true, t, false, f):
[true] f
Access host subnet area : [1.2.3.4] Read/Write? (true, t, false, f):
[true] f
Access host subnet area : [1.2.3.4] 0.0.0.0 ! remove this one
Read/Write? (true, t, false, f): [true] f
Access host subnet area : [1.2.3.4] Read/Write? (true, t, false, f):
[true]
Access host subnet area : [1.2.3.4] Read/Write? (true, t, false, f):
[true]
Committing configuration...done.
6. Remove the remaining IP address from the SNMP Access Control List if required:
> snmpconfig --set accesscontrol
SNMP access list configuration:
Access host subnet area : [1.2.3.4] Read/Write? (true, t, false, f):
[true]
Access host subnet area : [1.2.3.4] 0.0.0.0 Read/Write? (true, t, false,
f): [false] f
Access host subnet area : [1.2.3.4] 0.0.0.0 Read/Write? (true, t, false,
f): [false] f
Access host subnet area : [0.0.0.0] Read/Write? (true, t, false, f):
[false]
Access host subnet area : [1.2.3.4] 0.0.0.0 Read/Write? (true, t, false,
f): [true] f
Access host subnet area : [1.2.3.4] 0.0.0.0 Read/Write? (true, t, false,
f): [true] f
Committing configuration...done.
7. Check the access to SNMP control list:
> snmpconfig --show accesscontrol
SNMP access list configuration:
Entry 0: Access host subnet area 1.2.3.4 (rw)
Entry 1: No access host configured yet
Entry 2: No access host configured yet
Entry 3: No access host configured yet
Entry 4: No access host configured yet
Entry 5: No access host configured yet
8. Set MIB Capability:
> snmpconfig --set mibcapability
The SNMP Mib/Trap Capability has been set to support FE-MIB SW-MIB FA-
MIB HA-MIB SW-TRAP FA-TRAP HA-TRAP
FA-MIB (yes, y, no, n): [yes]
HP Insight Remote Support Advanced (A.05.70)Page 176 of 199