A.05.70 HP Insight Remote Support Advanced Managed Systems Configuration Guide (October 2011, 5900-1726)

Chapter 18
Network Storage System Configuration
Before you can monitor your Network Storage System devices you must:
1. Verify the monitored devices are supported by checking the Insight Remote Support Advanced
Release Notes.
2. "Configure SNMP on the File Serving Nodes" below.
3. "Start or Restart Insight Remote Support Advanced Services" on next page.
4. "Discover Nodes in Insight Remote Support Advanced or HP SIM" on page 157.
5. "Configure Entitlements" on page 157.
6. "Test the Configuration" on page 158.
Note the following limitations:
l For X9000 systems, the Insight Remote Support Advanced implementation is limited to hardware
events.
l Some manual configurations require that the X9320 and X9300 nodes be recognized as a X9000
solution. See section "Configure Entitlements" on page 157.
l Some manual configurations require that the X9320 and X9300 nodes be recognized as a X9000
solution. See section "Configure Entitlements" on page 157.
Configure SNMP on the File Serving Nodes
1. Run the /sbin/hpsnmpconfig script, which configures SNMP to integrate the Hosting Device
running on the Windows server with the HP System Management Homepage on the file serving node.
The script edits the /etc/snmp/snmpd.conf file, adding entries similar to the following:
# Following entries were added by HP Insight Management Agents at
# <date> <time> UTC <year>
dlmod cmaX /usr/lib64/libcmaX64.so
rwcommunity public 127.0.0.1
rocommunity public 127.0.0.1
rwcommunity public <Manager IP>
rocommunity public <Manager IP>
trapcommunity public
trapsink <Manager IP> public
syscontact
syslocation
# ---------------------- END --------------------
HP Insight Remote Support Advanced (A.05.70)Page 155 of 199