Manualshelf

A.05.70 HP Insight Remote Support Advanced Managed Systems Configuration Guide (October 2011, 5900-1726)

ManualsBrandsHP ManualsSoftwareHP Insight Remote Support Advanced Software
141142143144145146147148149150
Managed Systems Configuration Guide
Chapter 17: P4000 Storage Systems Migration Procedure
3. Select Hard disk 1 (verify that the Virtual Device Node is SCSI (0:0)).
4. Under Disk provisioning, changed the provisioned size to 8 GB.
5. Click OK.
6. Repeat these steps for Hard disk 2 (verify the Virtual Device Node is SCSI (0:1))
7. Using the VI Client, power on the VSA.
8. Find the VSA in the CMC and apply the upgrade.
Upgrade Software on Storage Nodes
1. Right-click the first storage node to upgrade and select Install Software. The Install Software
window opens.
2. Select from the list which storage nodes to upgrade.
3. Select the upgrade.
4. Click Install.
Verify Management Group Version
l When upgrading from version 7.x to release 8.5, 9.0, 9.5, or 10.0, the management group version will
not move to new release version until all storage nodes in the management group (and in the remote
management group if a Remote Copy relationship exists) are upgraded to SAN/iQ release 8.5, 9.0, 9.5,
or 10.0.
l When upgrading from version 7.x to release 8.5, 9.0, 9.5, or 10.0, the upgrade process validates the
hardware identity of all of the storage nodes in the management group. If this validation fails for any
reason, the management group version will not be upgraded to 8.5, 9.0, 9.5, or 10.0. For example, if a
management group has a mix of platforms, some of which are unsupported by a software release; then
only the supported platforms get upgraded successfully, the management group version will not be
upgraded if the unsupported platforms remain in that management group.
How to Verify Management Group Version
In the CMC navigation window, select the management group, and then select the Registration tab.
The management group version number is at the top of the Registration Information section, as shown in
the figure below.
Figure 16.4. Verifying the Management Group Version Number
HP Insight Remote Support Advanced (A.05.70)Page 142 of 199