A.05.70 HP Insight Remote Support Advanced HP StorageWorks P4000 Storage System Migration Guide (October 2011, 5900-1528)

task. For example, if the P4000 Family Configuration Collection runs at 7:30 a.m., configure the
System Health Check task to run at approximately 5:00 a.m. so that the System Health Check task
has two hours to complete before the P4000 Family Configuration Collection task starts.
12. Run the configuration collection by selecting Options → Status Polling → HP Service P4000 Family
Configuration Collection. Click Add Targets to select your systems, and then click the Run Now
button.
13. To verify that the P4000 Storage System(s) are communicating with the CMS, open CMC and select
at least one storage node and send a test trap to the CMS. Select SNMP in the left menu tree and open
the SNMP Traps tab. In the SNMP Trap Tasks drop-down list, select Send Test Trap.
NOTE: Note that in CMC 9.0 and 9.5, SNMP traps are configured at the Management Group level,
not at the node level.
Go to CMS configurations to verify that the test event was posted to the CMS logs. The CMC read-only
credentials were verified during device discovery when each SAN/iQ device was added to CMS
monitored listed.
1.4 Installing and Configuring Insight Remote Support Advanced 23