A.05.70 HP Insight Remote Support Advanced HP StorageWorks P4000 Storage System Migration Guide (October 2011, 5900-1528)

1. Open CMC.
2. If using SAN/iQ 8.5, verify that SNMP is enabled for each storage system. If using SAN/iQ 9.0, verify
that SNMP is enabled/configure in the Management Group.
NOTE: SAN/iQ ships by default with SNMP enabled for all storage systems and configured with the
“Default” Access Control list.
NOTE: SAN/iQ 9.0 and 9.5 Management Groups configure the CMS SNMP trap host destination
once at the Management Group level. Under SAN/iQ 8.5 users configure the CMS trap host destination
on each P4000 node. Under SAN/iQ 9.0 and 9.5 users can configure different severity Alert levels
to send from the Management Group. Under Insight Remote Support, configure each Management
Group to send v1 SNMP traps of Critical and Warning levels in Standard message text length.
a. Select SNMP in the left menu tree and open the SNMP General tab.
b. Verify that the Agent Status is enabled.
c. Verify that the P4000 Storage System SNMP Community String is set to public or the same value
configured in HP SIM for SNMP discovery.
d. In the Access Control field, verify that either Default is listed or the CMS host IP address is listed.
The Default option configures SNMP to be accessed by the public community string for all IP
addresses.
NOTE: The SNMP settings on the P4000 Storage Systems need to match the SNMP settings on
the CMS.
3. Select Alerts in the left menu tree, and verify that alerts are configured with the “trap” option for each
storage system.
14 P4000 Storage Systems Migration Procedure