HP Array Configuration Utility Command Line Interface for Integrity Linux Environments Support Notes Version 8.
© Copyright 2007-2011 Hewlett-Packard Development Company, L.P. Confidential computer software. Valid license from HP required for possession, use or copying. Consistent with FAR 12.211 and 12.212, Commercial Computer Software, Computer Software Documentation, and Technical Data for Commercial Items are licensed to the U.S. Government under vendor's standard commercial license. The information contained herein is subject to change without notice.
Table of Contents HP ACU-CLI Overview..........................................................................................................................4 Supported Configurations......................................................................................................................4 Installation and Usage Instructions........................................................................................................4 Installing HP ACU-CLI:............................................
HP ACU-CLI Overview The HP Array Configuration Utility Command Line Interface (HP ACU-CLI) is a command-line-based disk configuration tool that can be used to configure and manage Smart Array Controllers and RAID Array Controllers in Integrity Linux environments. HP ACU-CLI is available as a part of the HP Insight Foundation Suite for Integrity with Linux and can be obtained from the Linux on HP Integrity Servers web site: http://www.hp.
• • • • • rebooting, Linux might see logical drives that were previously not visible. This name mapping problem is common to all SCSI devices on Linux. Do not insert or remove a controller driver module when hpacucli is running. Stop the HP Storage Agents when deleting logical drives since HP Storage Agents keep all logical drives open. If all physical drives on a controller fail or are removed, software keys will not be saved to the controller.
NOTE: To avoid creating this adverse condition, the HP Integrity Essentials Foundation Pack for Linux installer will not install the HP ACU-CLI (hpacucli) product on these servers and this option is not displayed in the product installation menu. Further, if hpacucli is detected on the system, it is uninstalled by the installer. Workaround: If multiple logical drives are required on a given SmartArray controller, use the ORCA utility at the EFI shell to configure them.
Workaround: Ensure that you allow an adequate amount of time, commensurate with the storage size of your server, for the operation to complete. Do not attempt to execute additional commands until the hpacucli operation has finished. • Rebuild issue when Smart Array 6402 controller is installed in an rx4640 connected to internal volumes. THIS ISSUE WAS FIXED IN THE 7.65 RELEASE. ACU-CLI should perform a rescan of the SCSI bus as a result of running "rescan" or "pd show all" commands.
• OS fails to recognize configuration changes. THIS ISSUE WAS FIXED IN THE 7.65 RELEASE. When existing volumes are modified or deleted, or when new volumes are created using HP ACU-CLI, the operating system will not always be aware of the changes unless the system is rebooted. Workaround: You must reboot the system after making changes to existing volumes. • ACU-CLI cannot delete the last logical disk. THIS ISSUE WAS FIXED IN hpacucli8.40+hp-fc-enablement-1.1-13.
*5992-3868* Printed in the US
