HP Insight Management Agents 8.40 Managing ProLiant Servers with Linux HOW TO Whitepaper

Managing ProLiant Servers with Linux – HOWTO v8.40
26
Description These messages indicate a problem that occurred during initialization of the service. The
main reasons for failure include:
• Absence of the iLO driver
• iLO encountered problems and is in an undefined state
• The operating system is running out of resources (for example, memory, threads,
semaphores, and so on)
Recommended
action
Verify that the iLO Driver is installed and reboot the server.
Message 11 start failed. started and stopped. – failed.
Description This message indicates that the service terminated itself because of problems.
Recommended
action
Install Version 1 .1 .0-2 of the service. Verify that the iLO driver is installed and reboot the
server. If the problem persists, contact your HP field service Engineer.
Message 12 Dispatcher still sees %d clients...
Description A client does not respond properly to impending shut down. Consequently the service
waits for approximately 5 seconds, outputs this message, and exits.
Recommended
action
No action is required, since this message is informational. However, this message could
also indicate that the HP ProLiant Rack Daemon (cmarackd) has died.
Message 13 Checksum on EEPROM %2.2x do not match for header (%2.2x)
Description This message indicates that the EEPROMs in the infrastructure are corrupt.
Recommended
action
Contact your HP field service engineer for resolution.
Message 14 Error: copy ipmb response with negative length %d
Error: copy ipmb response with excessive length %d
Description These messages indicate that a corrupt response from the infrastructure was received.
Recommended
action
Reboot the HP ProLiant Power Module.