HP Insight Management Agents 8.40 Managing ProLiant Servers with Linux HOW TO Whitepaper

Managing ProLiant Servers with Linux – HOWTO v8.40
25
Recommended
action
No action is required, since this message is informational.
Message 6 Alert only seems to reach %d out of %d client applications
Description The alerts coming from the infrastructure seem to be dispatched to a subset of registered
clients only. Most likely a client terminated suddenly without properly deregistering itself.
Recommended
action
This message does not indicate a problem with the Rack Infrastructure Interface Service.
However, there might be a problem with the HP ProLiant Rack Daemon (cmarackd). Restart
cmarackd. If the problem persists, contact your HP field service engineer.
Message 7 iLO exceeded the number of allotted back offs, is it stuck?
Description iLO responds with a “backoff” command indicating a busy state, which is a temporary
condition. If this condition lasts too long (5000 tries), the message appears.
Recommended
action
Verify that iLO is not under extreme network load, such as a ping flood. Otherwise,
contact your HP field service engineer.
Message 8 Data returned is too short for any transaction
Description Data corruption from iLO has occurred. The data received is ignored.
Recommended
action
Reboot iLO by navigating to the Network Settings tab in the iLO Web interface and
clicking Apply. If you continue to see this message, contact your HP field service Engineer.
Message 9 watchdog sees no dispatch threads
cpqci watchdog: close channel!
cpqci watchdog: reopen channel!
Description These messages indicate that iLO was reset and that the service is trying to reopen
communication.
Recommended
action
No action is required, since this message is informational.
Message 10 Problems setting up shared memory
Problems setting up semaphores
Problems setting up local semaphore
Problems setting up watchdog thread
Problems setting up IPMI channel
Problems setting up dispatch thread
Problems setting up secondary dispatch thread
Problems setting up dispatch threads
Did not receive initial handshake
Problem pushing IPMI traffic over channel!
Problems setting up dispatch data
Problems setting up stats data
Problems setting up dynamic mem allocator!
Problems setting up hash table!
Problems setting up communication over channel!
Problems setting up watchdog thread!