HP Insight Management Agents 8.40 Installation Guide

Installation instructions for NetWare 17
Configuring agents
NOTE: CPQBSSA must be installed to enable Insight Manager to verify that the system is manageable.
To configure Management Agents for Servers for NetWare:
1. At the NetWare console prompt, enter the following command:
LOAD CPQAGIN
2. Select the Configure Existing NetWare Agents option to display a list of Management Agents for Servers to be
configured. The next screen enables you to select which agents you want to configure.
3. To select any additional agents that you want to load or remove, move the cursor to the preferred agent and
choose Yes or No. You can then move the cursor to select or remove additional agents or save the information
and continue.
4. Configure Management Agents for Servers for the following parameters:
• SNMP Monitor and Control support (community and monitor strings)—Use either CPQAGIN.NLM or
INETCFG to change the SNMP community and monitor strings.
• SNMP Set support—SNMP sets will not be accepted if a control community is not defined.
• Insight Manager Remote Reboot Polling Interval
The screens that follow depend on the individual Management Agents for Servers installed:
• CPQHOST can be configured to issue or not issue NetWare SAP packets.
• CPQTHRSA can be configured to support the maximum number of threshold entries.