HP Insight Management Agents 8.40 Installation Guide

Installation instructions for NetWare 13
Read this installation procedure completely before installing the software. The installation varies, depending on
whether you are installing all four of the Insight Management Agents for Servers components, or updating only
specific components.
To install the Server Agents for NetWare from the Management CD:
1. Insert the Management CD into the CD-ROM drive.
2. Mount the CD mounted as a NetWare volume.
3. Install the Insight Management Agents using either of the following processes:
• To install all Insight Management Agents for Servers components, type the following at the NetWare system
console:
LOAD [NetWare VOL]:\AGENTS\NETWARE\ENG\ COMPAQ\CPQAGIN
• The installation utility, CPQAGIN.NLM, installs and configures the Insight Management Agents for Servers
for NetWare.
• To install or update specific Insight Management Agents for Servers components, choose from the following
entries made at the NetWare system console.
• To update only the Insight Foundation Agents, enter the following command:
LOAD [NetWare VOL]:\AGENTS\NETWARE\ENG\ COMPAQ\CQMGHOST\CPQAGIN
• To update only the Insight Server Agents, enter the following command:
LOAD [NetWare VOL]:\AGENTS\NETWARE\ENG\ COMPAQ\ CQMGSERV\CPQAGIN
• To update only the Insight Storage Agents, enter the following command:
LOAD [NetWare VOL]:\AGENTS\NETWARE\ENG\ COMPAQ\ CQMGSTOR\CPQAGIN
• To update only the Insight NIC Agents, enter the following command:
LOAD [NetWare VOL]:\AGENTS\NETWARE\ENG\ COMPAQ\ CQMGNICS\CPQAGIN
4. Follow the onscreen instructions, pressing the F1 key for online help, if needed.
5. After the installation is complete, reboot the system to enable the Insight Management Agents for Servers for
NetWare. These agents automatically start each time you reset the system.
Disabling Web-enabled Server Agent from a NetWare server
If you chose to enable Web-based Management when you installed the Insight Management Agents for Servers for
NetWare and would like to disable it later, do the following from the NetWare server console:
1. Load CPQAGIN.
2. Select the Configure Existing NetWare Agents option.
3. Select the line that specifies the load of CPQWEBAG and select No.
4. Save changes and exit CPQAGIN.
This procedure prevents the web-enabled Server Agent from loading.
Installing HP Power Management
HP Power Manager is a set of sophisticated UPS software management tools that come with HP UPS systems. It
provides comprehensive configuration and management of UPS systems. Power Manager comes with two main
components: server and console. For complete information on installation and configuration of the Power Manager
components, see the HP Power Manager documentation.
Server component
The Power Manager server component is installed from the Management CD. Power Manager is backward
compatible with Insight Management Agents for Servers. Existing Insight Manager consoles see the same data with
Power Manager as with Insight Management Agents for Servers.
IMPORTANT: Power Manager requires Insight Server Management Agents v3.30 or later. You must install
Power Manager software after installing Insight Management Agents for Servers software.