HP ProLiant Network Adapter Software and Configuration Guide

Configuration and diagnostics 21
• PXE-E09: Unexpected UNDI loader error. Status == xx
The UNDI loader returned an unknown error status. xx is the returned status.
• PXE-E20: BIOS extended memory copy error.
BIOS cannot move the image into the extended memory.
• PXE-E20: BIOS extended memory copy error. AH == xx
An error occurred while copying the image to the extended memory. xx is the BIOS failure code.
• PXE-E51: No DHCP or BOOTP offers received.
The Boot Agent does not receive DHCP or BOOTP responses to the initial request. Be sure that your
DHCP server (and/or proxyDHCP server, if one is in use) is properly configured and has sufficient IP
addresses available for lease. If you are using BOOTP, be sure that the BOOTP service is running and
is properly configured.
• PXE-E53: No boot filename received.
The Boot Agent receives a DHCP or BOOTP offer, but does not receive a valid filename to download.
If you are using PXE, check your PXE and BINL configuration. If you are using BOOTP, be sure that the
TFTP service is running and that the specific path and filename are correct.
• PXE-E61: Media test failure
The adapter does not detect a link. Be sure that the cable is not damaged and is attached to a working
hub or switch. Verify that the Link LED on the rear the adapter is illuminated.
• PXE-EC1: Base-code ROM ID structure was not found.
No base code is located. An incorrect flash image is installed or the image is corrupted. Update the
flash image.
• PXE-EC3: BC ROM ID structure is invalid.
The base code cannot be installed. An incorrect flash image is installed or the image is corrupted.
Update the flash image.
• PXE-EC4: UNDI ROM ID structure was not found.
The UNDI ROM ID structure signature is incorrect. An incorrect flash image is installed or the image is
corrupted. Update the flash image.
• PXE-EC5: UNDI ROM ID structure is invalid.
The structure length is incorrect. An incorrect flash image is installed or the image is corrupted. Update
the flash image.
• PXE-EC6: UNDI driver image is invalid.
The UNDI driver image signature is invalid. An incorrect flash image is installed or the image is
corrupted. Update the flash image.
• PXE-EC8: !PXE structure was not found in UNDI driver code segment.
The Boot Agent cannot locate the !PXE structure resource. An incorrect flash image is installed or the
image is corrupted. Update the flash image.
• PXE-EC9: PXENV + structure was not found in UNDI driver code segment.
The Boot Agent cannot locate the PXENV+ structure. An incorrect flash image is installed or the image
is corrupted. Update the flash image.
• PXE-M0F: Exiting Intel Boot Agent.
Ending execution of the ROM image.