HP ProLiant Network Adapter Software and Configuration Guide

Configuration and diagnostics 20
• 11–FLASH memory is disabled for flash firmware
• 12–FLASH memory too small for selected image
• 13–Programming iSCSI boot configurations failed
• 14–System memory allocation failed
• 15–File operation failed
• 16–FCoE operation failed
Boot Agent messages
The error and information messages listed below might be displayed during initialization. Possible causes
and how to avoid an error condition are provided where applicable.
• Invalid PMM function number
PMM is not installed or is not working correctly. Try updating the BIOS.
• PMM allocation error
PMM could not or did not allocate the requested amount of memory for driver usage.
• PXE-E00: This system does not have enough free conventional memory. The Boot Agent cannot
continue.
System does not have enough free memory to run PXE image. The Boot Agent was unable to find
enough free base memory (below 640K) to install the PXE client software. The system cannot boot via
PXE in its current configuration. The error returns control to the BIOS and the system does not attempt to
remote boot. If this error persists, update your system's BIOS to the most-recent version. Contact your
system administrator or HP customer support to resolve the problem.
• PXE-E01: PCI Vendor and Device IDs do not match!
Image vendor and device ID do not match those located on the card. Be sure the correct flash image is
installed on the adapter.
• PXE-E04: Error reading PCI configuration space. The Boot Agent cannot continue.
PCI configuration space could not be read. The system is not PCI compliant. The Boot Agent is unable
to read one or more of the PCI configuration registers. The adapter might be misconfigured, or the
wrong Boot Agent image might be installed on the adapter. The Boot Agent returns control to the BIOS
and does not attempt to remote boot. Update the flash image. If this does not solve the problem, contact
your system administrator or HP Customer Support.
• PXE-E05: The LAN adapter's configuration is corrupted or has not been initialized. The Boot Agent
cannot continue.
The adapter's EEPROM is corrupted. The Boot Agent determines that the adapter EEPROM checksum is
incorrect. The agent returns control to the BIOS and does not attempt to remote boot. Update the flash
image. If this does not solve the problem, contact your system administrator or HP Customer Support.
• PXE-E06: Option ROM requires DDIM support.
The system BIOS does not support DDIM. The BIOS does not support the mapping of the PCI expansion
ROMs into upper memory as required by the PCI specification. The Boot Agent cannot function in this
system. The Boot Agent returns control to the BIOS and does not attempt to remote boot. Update the
BIOS on your system. If updating the BIOS does not solve the problem, contact your system
administrator or HP Customer Support.
• PXE-E07: PCI BIOS calls not supported.
BIOS-level PCI services are not available. The system is not PCI compliant.