Manualshelf

HP ProLiant Network Adapter Software and Configuration Guide

ManualsBrandsHP ManualsSoftwareHP Insight Foundation Suite for ProLiant Unlimited use Software License
11121314151617181920
Configuration and diagnostics 11
o
Range = Disabled; Enabled
• Priority and VLAN. Enables or disables the ability to insert or remove the 802.1q tags for priority and
VLAN.
o Default = Priority & VLAN Enabled
o Range = Priority & VLAN Disabled; Priority & VLAN Enabled; Priority Enabled; VLAN Enabled
• Receive Buffers. The size, in bytes, of the receive buffers that the hardware can support. This size is
hardware-dependent and can include data buffers, buffer descriptors, and so on.
o Default = 256
• TCP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of TCP
Checksum over IPv4 packets.
o Default = Rx/Tx Enable
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
• TCP Checksum Offload (IPv6). Describes whether the device enabled or disabled the calculation of TCP
checksum over IPv6 packets.
o Default = Rx/Tx Enable
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
• Transmit Buffers. The size, in bytes, of the transmit buffers that the hardware can support. This size is
hardware-dependent and can include data buffers, buffer descriptors, and so forth.
o Default = 512 Bytes
• UDP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of UDP
checksum over IPv4 packets.
o Default = Rx/Tx Enable
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
• UDP Checksum Offload (IPv6). Describes whether the device enabled or disabled the calculation of UDP
checksum over IPv6 packets.
o Default = Rx/Tx Enable
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
• Wait for Link. Determines if the driver waits for auto-negotiation to be successful before reporting the
link state. If disabled, the driver does not wait for auto-negotiation. If enabled, the driver does wait for
auto-negotiation. If this feature is on, and the speed is not set to auto-negotiation, the driver will wait for
a short time for link to complete before reporting the link state.
o Default = Auto Detect
o Range = Auto Detect; Off; On
• Wake on Link Settings. Wakes the computer if the network connection establishes link while the
computer is in standby mode. To wake up a system from an S5 state, PME must be enabled.
o Default = Disabled
o Range = Disable, Forced; OS Controlled
• Wake On Settings. Available only when Enable PME is enabled. Allows you to choose what types of
packets will cause the adapter to wake.
o Default for NC364m = OS Controlled