HP ProLiant Network Adapter Software and Configuration Guide

Configuration and diagnostics 10
o
Rx Enable. PAUSE frame receipt is enabled
o Rx/Tx Enable (Default). PAUSE frame receipt and transmission is enabled
• Gigabit Master Slave Mode. Determines IEEE 802.3ab Master-Slave resolution during gigabit auto
negotiation.
o Default = Auto Detect
o Range = Auto Detect; Force Master Mode; Force Slave Mode
• Interrupt moderation. If enabled, helps to reduce number of interrupts per packet, which reduces CPU
utilization, while maintaining the same throughput. This feature is useful under heavy network traffic
conditions.
o Default = Enabled
o Range = Disabled; Enabled
• Interrupt moderation rate. Determines the amount of interrupts per second when the Interrupt
moderation parameter is enabled.
o Default = Adaptive
o Range = Adaptive; Extreme; High; Low; Medium; Minimal; Off
• IPv4 Checksum Offload. Describes whether the device enabled or disabled the calculation of IPv4
checksums.
o Default = Rx/Tx Enable
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
• Jumbo Packet. The size, in bytes, of the largest supported Jumbo Packet (an Ethernet frame that is
greater than 1514 bytes) that the hardware can support.
o Default = Disabled
o Range = 4088 Bytes; 9014 Bytes; Disabled
• Large Send Offload Version 2 (IPv4). Describes whether the device enabled or disabled the
segmentation of large TCP packets over IPv4 for large send offload version 2 (LSOv2).
o Default = Enabled
o Range = Disabled; Enabled
• Large Send Offload Version 2 (IPv6). Describes whether the device enabled or disabled the
segmentation of large TCP packets over IPv6 for large send offload version 2 (LSOv2).
o Default = Enabled
o Range = Disabled; Enabled
• Link Speed & Duplex. Sets the connection speed to the network and mode. Full-Duplex Mode allows the
adapter to transmit and receive network data simultaneously.
o Default = Auto Negotiation
• Locally Administered Address. Specifies the user-defined MAC Address of the adapter, which overrides
the burned-in MAC Address. This box is disabled if the selected adapter has been teamed.
o Default = Not Present
o Range: Value; Not Present
• Log Link State Event. Enables or disables the logging of link state changes. If enabled, a link up change
event or a link down change event generates a message that is displayed in the system event logger.
o Default = Enabled