HP ProLiant SCCM 2007 Integration Kit (v 2013.09.0) User Guide

Table 1 Hardware configuration tasks (continued)
Underlying STK utilityDescriptionTask
hpacuscripting.exeSets the Smart Array RAID configuration.Smart Array
hponcfg.exeSets the iLO 2 or later configuration.iLO
• The tasks are designed to set/write a configuration, not get/read/capture a configuration.
• The Smart Array configuration task is designed to configure only internal controllers and disks,
not network-based storage.
NOTE: The Set BIOS Configuration task supports all ProLiant generations. If you use a custom
conrep or hprcu input file, the task sequence will become ProLiant generation specific. For
example, if you specify a custom conrep input file, the task sequence will fail on ProLiant Gen8 or
later target servers.
There is a custom task editor for each task. For example:
The Configuration file / Command line parameters field allows selecting one of the provided
filenames/parameters or typing in a custom filename/parameters. The pre-supplied files are located
in .\OSD\Lib\Packages\Deployment\HP\ProLiant\HWConfig. The files provided are
listed in Table 2 (page 16).
Table 2 Pre-supplied files
DescriptionFile
Does not set anythingconrep-d.xml
Does not set anythinghprcu-d.xml
Creates a default configurationacu-rd.ini
Creates one array with RAID 0acu-r0.ini
Creates one array with RAID 1 (requires two drives)acu-r1.ini
Creates one array with RAID 5 (requires three or more
drives)
acu-r5.ini
16 Reference