HP Insight Control Server Provisioning 7.3 Update 1 Installation Guide
Table Of Contents
- HP Insight Control Server Provisioning 7.3 Update 1 Installation Guide
- Contents
- 1 Introduction/overview
- 2 Requirements and networking considerations
- 3 Installing your Insight Control server provisioning appliance for the first time
- Overview of the first time set up steps
- Get the software for a first time install
- Install Insight Control server provisioning on VMware vSphere/ESXi hypervisor
- Install Insight Control server provisioning on Microsoft Hyper-V hypervisor
- Log in to the appliance and configure appliance networking
- Accessing your appliance from a browser for the first time
- Next steps
- 4 Updating from version 7.2.2 to 7.3.1
- 5 DHCP server setup
- 6 Setting up the Media Server
- Introduction to the Media Server
- Introduction to the Insight Control server provisioning Media Server setup utility
- Requirements for setting up your Media Server
- Procedure for using the Insight Control server provisioning Media Server setup utility
- Changes made to your web server by Insight Control server provisioning Media Server setup utility
- 7 Generating and uploading WinPE to the appliance
- 8 Recommended actions after initial setup
- 9 Support and other resources
- 10 Documentation feedback
- A Updating from version 7.2 or 7.2.1 to 7.2.2
- Best practices for a successful update to 7.2.2
- Get the 7.2.2 update software and prepare it for use
- Prerequisites for update from 7.2/7.2.1 to 7.2.2
- Instructions for updating from 7.2 or 7.2.1 to 7.2.2
- What you need to do after installing the 7.2.2 update
- Changing from single NIC to multi-NIC (optional)
- Instructions for recovering from a failed 7.2.2 update
- REST API call to upload the 7.2.2 update file
- Glossary
- Index
by the deployment engine within the appliance. It is used to communicate with a target server’s
deployment interface IP address.
This configuration only requires the first network adapter on the VM.
Select OK or Logout. Selecting the OK button applies the information you have supplied. Allow
15 minutes while the appliance configures and reboots to complete the configuration. Selecting
the Logout button exits from the appliance without saving the appliance networking information.
NOTE: The password you set for the account administrator will be applied even if you select
Logout.
NOTE: After your initial login to the appliance via the vSphere Client or Hyper-V Manager
Console, you may use a browser to access the appliance. However, you may also access the
appliance via the Console if you wish.
Configure Deployment IP on a different network
To begin configuring the Deployment IP, select the 2 Deployment network interface in the Appliance
Networking screen. A set of fields is displayed for you to configure the Deployment IP (as shown
below).
IMPORTANT: Once the Deployment IP address is set during first time setup it cannot be changed.
Figure 10 Deployment IP configuration on a different network edit fields
26 Installing your Insight Control server provisioning appliance for the first time