HP Insight Control Server Provisioning 7.3 Update 1 Installation Guide
Table Of Contents
- HP Insight Control Server Provisioning 7.3 Update 1 Installation Guide
- Contents
- 1 Introduction/overview
- 2 Requirements and networking considerations
- 3 Installing your Insight Control server provisioning appliance for the first time
- Overview of the first time set up steps
- Get the software for a first time install
- Install Insight Control server provisioning on VMware vSphere/ESXi hypervisor
- Install Insight Control server provisioning on Microsoft Hyper-V hypervisor
- Log in to the appliance and configure appliance networking
- Accessing your appliance from a browser for the first time
- Next steps
- 4 Updating from version 7.2.2 to 7.3.1
- 5 DHCP server setup
- 6 Setting up the Media Server
- Introduction to the Media Server
- Introduction to the Insight Control server provisioning Media Server setup utility
- Requirements for setting up your Media Server
- Procedure for using the Insight Control server provisioning Media Server setup utility
- Changes made to your web server by Insight Control server provisioning Media Server setup utility
- 7 Generating and uploading WinPE to the appliance
- 8 Recommended actions after initial setup
- 9 Support and other resources
- 10 Documentation feedback
- A Updating from version 7.2 or 7.2.1 to 7.2.2
- Best practices for a successful update to 7.2.2
- Get the 7.2.2 update software and prepare it for use
- Prerequisites for update from 7.2/7.2.1 to 7.2.2
- Instructions for updating from 7.2 or 7.2.1 to 7.2.2
- What you need to do after installing the 7.2.2 update
- Changing from single NIC to multi-NIC (optional)
- Instructions for recovering from a failed 7.2.2 update
- REST API call to upload the 7.2.2 update file
- Glossary
- Index
Figure 6 Set a new password
IMPORTANT: Make sure you remember the new administrator password. Note that there
is a password reset service if needed.
Configure appliance networking
HP Insight Control server provisioning requires you to configure an Appliance IP and a Deployment
IP and corresponding netmask. See “Appliance networking considerations” (page 10) for additional
information. During first time setup you can configure the Appliance IP and Deployment IP on a
single NIC or you can configure the Appliance IP and Deployment IP on different NICs. Instructions
for single NIC and multi-NIC configuration are provided below.
You can switch from single NIC to multi-NIC if you need to (see the online help topic “Change
from single NIC to multi-NIC” for details).
IMPORTANT: Once you set the Deployment IP address during first time setup it cannot be changed
even if you switch between single and multi-NIC.
Configure appliance networking from the Appliance Networking screen (shown below).
22 Installing your Insight Control server provisioning appliance for the first time