Manualshelf

HP Insight Control Server Provisioning 7.3 Update 1 Build Plans Reference Guide

ManualsBrandsHP ManualsSoftwareHP Insight Control including 1yr 24x7 Technical Support and Updates Single Server License
41424344454647484950
46
Ethernet 3
HP NC553i Dual Port FlexFabric 10G...#2
14
Disconnected
18-A9-05-C5-E1-B4
10 Gbps
Table 10: Configure NIC Teaming for Windows sample parameters used for target server with network adapters setup
as provided in Table 9.
Parameters
Description
Status,Up
Teams all NICs that are active
Name,Ethernet,Ethernet 2
Teams the first and second NIC
MacAddress,18-A9-05-C5-E1-B3,18-A9-05-C5-E1-B4
Teams the second and third NICs
Custom Attributes: None
Continue SuSE AutoYaST Installation
Causes the SuSE AutoYaST installation to continue after it was stalled for HP SA Agent injection or other tasks before the
reboot into the second phase of the SuSE AutoYaST installation process.
Type: OGFS
Parameters: None
Custom Attributes: None
Control Server Bootmode
Configures the boot mode on a target server that supports UEFI and then powers off the server. If the server is already
configured with the specified boot mode, no action is performed.
Type: OGFS
Requirement:
HP ProLiant server with iLO that supports UEFI and is capable of switching between UEFI and Legacy boot
modes.
Required Parameter:
--bootmode=mode where mode is one of the following:
o LEGACY - switch to "Legacy BIOS" boot mode (Not UEFI)
o UEFI_OPTIMIZED - switch to UEFI mode w/ optimized boot enabled which provides improved boot
time
o UEFI - switch to UEFI non optimized boot mode. This is needed for certain legacy OS e.g. Windows
2008 SP2 and Windows 2008 R2 SP1
o UEFI_OPTIMIZED_SECURE - switch to UEFI mode with optimized boot and secure boot mode
enabled. Not supported on ProLiant Gen8 or earlier servers.
The mode must be set. There is no default value if mode is not set.
Custom Attributes: None
Copy Boot Media
Copies files needed to boot the installer environment to the stub partition.
This is one of the scripts used to prepare a server for a Linux installation. It should follow the Create Stub Partition script.
If no parameters are given, the script will check the installation media and figure out the files that the installer needs in
order to boot.
Type: Unix
Optional Parameters: