Manualshelf

HP Insight Control Server Provisioning 7.3 Update 1 Build Plans Reference Guide

ManualsBrandsHP ManualsSoftwareHP Insight Control including 1yr 24x7 Technical Support and Updates Single Server License
31323334353637383940
36
Requirements: HP ProLiant server with iLO and a Smart Array controller
Custom Attributes: None
ProLiant HW - Smart Array Set RAID 1
Sets the HP Smart Array configuration for RAID 1 using two drives.
This is a sample build plan that can be modified to set any Smart Array settings. Just replace the configuration file with
one that specifies the settings you want. The configuration file format is defined by the ProLiant Scripting Toolkit SSACLI
scripting utility.
IMPORTANT: Any existing configuration is cleared, resulting in loss of existing data on the Smart Array. Additionally, the
server's state will change to unmanaged, due to potential loss of critical identification and agent association data.
Requirements: HP ProLiant server with iLO and a Smart Array controller
Custom Attributes: None
ProLiant HW - Switch to Legacy BIOS boot mode and Power Off
Switches the HP ProLiant target server that supports UEFI to Legacy BIOS boot mode and powers it off. If the boot mode
switching is not successful, the target server will stay powered on and the build plan will fail. If the target is a non-UEFI
server, this build plan will do nothing and pass successfully.
The parameter to the Control Server Bootmode script is --bootmode=LEGACY
Requirement:
HP ProLiant server with iLO that supports UEFI and is capable of switching between UEFI and Legacy boot
modes.
Custom Attributes: None
ProLiant HW - Switch to UEFI boot mode and Power Off
Switches the HP ProLiant target server that supports UEFI to UEFI boot mode and powers it off. If the boot mode
switching is not successful, the target server will stay powered on and the build plan will fail. If the target is a non-UEFI
server, this build plan will do nothing and pass successfully.
The parameter to the Control Server Bootmode script is --bootmode=UEFI_OPTIMIZED.
Requirement:
HP ProLiant server with iLO that supports UEFI and is capable of switching between UEFI and Legacy boot
modes.
Custom Attributes: None
ProLiant HW - System ROM Capture Settings
Captures the ProLiant System ROM settings into a configuration file. The configuration file is stored on the target server
and then uploaded to the appliance.
The configuration file format is defined by the HP System ROM scripting utility and may be used as input for the Manage
System ROM Configuration script.
Requirements: HP ProLiant server with iLO
Required Custom Attribute: configuration_location – The absolute filename of the captured configuration xml on the
target server. This custom attribute is already set on the HP supplied build plan, but can be modified if you make a copy
of the build plan.
ProLiant HW - System ROM Enable Boot from SAN on Bladeserver
Configures the ProLiant BladeSystem ROM to enable Boot from SAN functionality.