HP Insight Control Server Provisioning 7.2 Update 2 Installation Guide

NOTE: In Multi-NIC mode, the appliance can access the iLOs through either the Appliance or
Deployment networks, depending on your requirements. No special configuration changes are
required for this.
NOTE: New Insight Control server provisioning appliances for version 7.2.2 come with two
network interfaces, however, if you are updating to 7.2.2 from a previous release, your original
appliance only had one NIC. If you wish to migrate to Multi-NIC mode see the online help topic
“Change from single NIC to multi-NIC”.
Once you have installed the Insight Control server provisioning appliance, see “Log in to the
appliance and configure appliance networking” (page 18) for details on how to configure appliance
networking.
The following diagrams illustrate the way the two appliance networking modes should be configured.
Figure 1 Single NIC Mode Example
IC server provisioning
Appliance
NIC 1
Appliance IP
Deployment IP
NIC 2
Not Used
Target Server
Single Network
NIC
Other NIC
NIC
Deployment NIC
iLO
Management
web browser
Media Server
Internet
In single NIC mode, all systems are connected to or are reachable from the one network.
Appliance networking considerations 9