HP Insight Control Server Provisioning 7.2 Update 2 Installation Guide

Routing (CIDR) mask representing the number of bits reserved for network identification. Valid

CIDR values are 1 to 30, inclusive.

• Gateway address: This field is not required, but HP strongly suggests configuring it to ensure

access to the appliance. Specify the IP address for the network interface on your router.

• Preferred DNS server: IP address of your preferred DNS server. Not required.

• Alternate DNS server: IP address of your alternate DNS server. Not required.

Continue with one of the following to configure the Deployment IP:

• “Configure Deployment IP on the same network” (page 23)

• “Configure Deployment IP on a different network” (page 24)

Configure Deployment IP on the same network

To begin configuring the Deployment IP, select the 2 Deployment network interface in the Appliance

Networking screen. A set of fields is displayed for you to configure the Deployment IP (as shown

below).

Figure 9 Deployment IP configuration on same network edit fields

To configure the Deployment IP to use the same network adapter as the Appliance IP, select Shared

with management interface and enter the IP address for the Deployment network interface. Since

you selected Shared with management interface (which means shared with the appliance NIC)

above, the IP address must be on the same network as the Appliance IP. This is the IP address used